Calling Up; Destinations - Mercedes-Benz COMAND Operating Instructions Manual

Destination entry
56
Irrespective of the option, press the 9
X
button to confirm your selection.
The address entry menu appears again. The
destination address selected has been
entered.
i
Further information on "Last
destinations" memory can be found on
( page 80).
Y
Entering a destination using the map
Calling up the map
To switch to navigation mode: press the
X
Ø function button.
To show the menu: press the 9 button.
X
Select Destination
X
menu bar using the =;:
buttons and press the 9 button to confirm.
Select Using Map
X
to confirm.
You see the map with the crosshair.
Map with crosshair
Current vehicle position
:
Crosshair
;
Details of the crosshair position
=
Map scale selected
?
Display = depends on the settings selected
in "Information on map" (
current street name can be shown, provided
the digital map contains the necessary data,
or the coordinates of the crosshair if the geo-
in the navigation
and press the 9 button
page 84). The
Y
coordinate display is switched on and the
GPS signal is strong enough.
Moving the map and selecting the
destination
Scroll the map using the =;9
X
or : button.
To set the map scale: press the U or
X
T button.
The scale bar appears.
Press the U button to zoom out of the
X
map.
Press the T button to zoom in on the
X
map.
To select a destination: press the 9
X
button.
If the crosshair is located outside the digital
map, it is not possible to calculate a route
to this destination. You will see the
crosshair is off the map
the crosshair is located over a body of
water, you will see the message:
destination is in a body of water.
Please select another destination.
Select OK and press the 9 button to
X
confirm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the entry Destination From
To start route calculation: select
X
and press the 9 button to confirm.
The
message. If
The
Map.
Start