Previous Destinations - Mercedes-Benz COMAND control panel Operating Instructions Manual

Select a category, e.g. Home, and press W
X
to confirm.
You will see the address book either with
the character bar or as a selection list.
To select an address book entry:
X
proceed as described in the "Searching for
an address book entry" section
( page 136).
Y
COMAND stores the data if the address
book entry selected does not yet contain
navigable address data.
If the selected address book entry already
contains navigable address data, a prompt
will appear asking whether you wish to
overwrite the existing data.
Select Yes or No and press W to confirm.
X
If you select Yes, COMAND stores the data.
Deleting a destination or the home
address from the destination memory
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
Select From Memory
X
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
X
character bar: proceed as described in the
"Entering characters using the character
bar" section ( page 31).
Y
Option 2: destination memory list as
X
selection list: select a destination by
in the navigation
and press W to

Previous destinations

turning cVd the COMAND controller and
press W to confirm.
You see the address data of the selected
entry.
Select Delete and press W to confirm.
X
A prompt appears asking whether you wish
to delete the destination.
Select Yes or No and press W to confirm.
X
If you select Yes, COMAND deletes the
destination. You will see a message to this
effect.
If you select No, the process will be
canceled.
i
If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
has been started. If the memory is full,
COMAND deletes the oldest destination. You
can also save a destination from the list of
previous destinations in the destination
memory. It will be stored there permanently.
Storing a destination permanently in
the destination memory
Proceed as described in the "From the list
X
of previous destinations" section
( page 96).
Y
97
Z