Previous Destinations - Mercedes-Benz COMAND control panel Operating Instructions Manual

Select a category, e.g. Home, and press W
X
to confirm.
You will see the address book either with
the character bar or as a selection list.
To select an address book entry:
X
proceed as described in the "Searching for
an address book entry" section
( page 112).
Y
COMAND stores the data if the address
book entry selected does not yet contain
navigable address data.
If the selected address book entry already
contains navigable address data, a prompt
will appear asking whether you wish to
overwrite the existing data.
Select Yes or No and press W to confirm.
X
If you select Yes, COMAND stores the data.
Deleting a destination or the home
address from the destination memory
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
Select Dest. in the navigation system
X
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
Select From Memory and press W to
X
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
X
character bar: proceed as described in the
"Entering characters using the character
bar" section ( page 27).
Y
Option 2: destination memory list as
X
selection list: select a destination by
turning cVd the COMAND controller and
press W to confirm.
You see the address data of the selected
entry.

Previous destinations

Select Delete and press W to confirm.
X
A prompt appears asking whether you wish
to delete the destination.
Select Yes or No and press W to confirm.
X
If you select Yes, COMAND deletes the
destination. You will see a message to this
effect.
If you select No, the process will be aborted.
i
If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
was started. If the memory is full, COMAND
deletes the oldest destination. You can also
store one destination from the list of previous
destinations in the destination memory. It will
be stored there permanently.
Storing a destination permanently in
the destination memory
Proceed as described in the "From the list
X
of previous destinations" section
( page 82).
Y
Storing the vehicle position in the list
of previous destinations
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
83
Z