Storing Destinations - Mercedes-Benz COMAND Operating Instructions Manual

To select Traffic Traffic Information
X
turn and press the controller.
Select Incidents, Incidents
X
Flow Flow.
The display is on O or off ª.
Reading out traffic reports on the
route
Introduction
The read-aloud function is only available while
route guidance is active. It reads out traffic
reports affecting the current route.
You can select from the following text reader
properties:
Language ( page 45)
R
Y
Text reader speed (
R
You can start the text reader function
manually or set it to automatic.
Starting the text reader function
manually
To switch to navigation mode: press the
X
Ø button.
To show the menu: press the controller.
X
To select Traffic Traffic: turn the controller and
X
press to confirm.
Select Read out all messages on Read out all messages on
X
route route.
COMAND reads out the reports in
sequence.
i
If no reports are available for the route,
the Read out all messages on route Read out all messages on route
menu item is gray and cannot be selected.
To cancel the read-aloud function: select
X
Cancel Read-Aloud Function Cancel Read-Aloud
COMAND reads out the current report and
then exits the read-aloud function.
Automatic read-aloud function
To switch to navigation mode: press the
X
Ø button.
Information On On Map Map:
Speed & & Flow Speed Flow or Free Free
page 41)
Y
Function.

Storing destinations

To show the menu: press the controller.
X
To select Traffic: turn the controller and Traffic
X
press to confirm.
Select Read Traffic Announcements Read Traffic Announcements
X
Automatically Automatically.
Depending on the previous state, switch
the option on O or off ª.
Recalculating the route dynamically
The Dynamic Traffic Route Dynamic Traffic Route
takes into account all of the traffic reports it
receives for the current route when
calculating the route (
If you have selected Dynamic Traffic Dynamic Traffic
Route Route as the route type, COMAND guides you
to your destination along the updated route.
Storing destinations
General notes
If a route to a destination has been calculated,
COMAND saves the destination to the last
destinations memory. If the memory is full,
COMAND overwrites the oldest destination.
When you save the current vehicle position or
a crosshair position, this position is stored in
the "Last destinations" memory.
You can permanently save destinations in the
address book. For instance, this is possible
immediately after entering an address or
saving it in the "Last destinations" memory.
route type
page 72).
Y
Z
105