Installing The Nvram; Figure 3-7 Removing And Installing The Nvram - Sun Microsystems Ultra 25 Service Manual

MAC address
Removing and Installing the NVRAM
FIGURE 3-7
3. Set the NVRAM aside on an antistatic mat.
3.4.2

Installing the NVRAM

The NVRAM installs directly onto the motherboard. There are no additional
fasteners or cables.
1. Power off the system and attach an antistatic wrist strap. Open and position the
chassis, and remove the access panel.
Refer to "Powering Off the Workstation" on page 2-4.
2. Align the NVRAM key to the NVRAM connector key on the motherboard
(
FIGURE 3-7
3. Press the NVRAM down into the connector.
4. Ensure that the NVRAM is tight in its connector.
3-12 Sun Ultra 45 and Ultra 25 Workstations Service and Diagnostics Manual • May 2006
).
NVRAM key