Disconnecting the Cables From the Hard Drive Backplane
FIGURE 4-2
2. Remove all hard drives.
See "Replacing a Hard Drive" on page 4-2.
3. Remove long PCI cards if they are covering the hard drive backplane cables.
Refer to "Removing a PCI Card" on page 3-14. Set these components onto an
antistatic mat.
4. Disconnect the cables from the following connectors
Hard drive backplane signal cable from J4 of the hard drive backplane and J42 on
the motherboard (
Power cable P3 from backplane connector J2
5. Using a No. 2 Phillips screwdriver, remove the two screws from the hard drive
backplane.
)
FIGURE 4-2
Chapter 4 Replacing Storage Devices
4-5