Table of Contents
Advertisement
2.3.1
Opening the Workstation
1. Press down the two latches on the side cover and lift the cover off the workstation
(
FIGURE 2-4
2. Using both hands, place the workstation on its side.
3. Pivot the workstation support stabilizer underneath the workstation.
4. Attach the antistatic wrist strap.
Wrap the adhesive portion around your wrist. Attach the copper end to the rear vent
of the chassis. Ensure that the location does not interfere with your service
procedure.
5. Remove the access panel:
a. Slide the lock block towards the front of the system.
b. Press and release the two latches and lift the access panel.
6. Disconnect the power cord from the workstation.
7. If necessary, remove any long PCI cards and pull the fan tray out of the chassis.
8. Find your removal or replacement procedure (
2-6
Sun Ultra 45 and Ultra 25 Workstations Service and Diagnostics Manual • May 2006
).
).
TABLE 2-1
Advertisement
Table of Contents
