Esmc Mode - Cisco ASR 901 Command Reference Manual

Chapter 1 CLI Command Reference

esmc mode

To enable or disable ESMC process on the interface, use the esmc mode command in interface
configuration mode. Use the no form of this command to disable the configuration
Syntax Description
tx
rx
Command Default
Enabled for synchronous mode and disabled for asynchronous mode.
Command Modes Interface configuration (config-if)
Command History Release
15.1(2)SNG
Usage Guidelines
If the interface is configured as line source but does not receive ESMC message from peer node on the
interface, then the interface is removed from selectable clock source list. By default this is enabled for
synchronous mode and disabled for asynchronous mode.
Note This command is not supported for non-synchronous ethernet interfaces.
Examples
The following example shows how to enable ESMC process:
Router(config-if)#esmc mode tx
Related Commands Command
esmc process
show esmc
show interfaces accounting
OL-26031-07
esmc mode <tx | rx >
no esmc mode
Transmission mode
Receiving mode
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Description
Enables the ESMC process in a router.
Displays the enabled ESMCs in a router.
Displays the number of packets of each protocol type that have been
sent through all configured interfaces.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
esmc mode
1-45