Xconnect Logging Redundancy - Cisco ASR 901 Command Reference Manual

xconnect logging redundancy

xconnect logging redundancy
To enable system message log (syslog) reporting of the status of the xconnect redundancy group, use the
xconnect logging redundancy command in global configuration mode. To disable syslog reporting of
the status of the xconnect redundancy group, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
Syslog reporting of the status of the xconnect redundancy group is disabled.
Command Modes Global configuration
Command History Release
15.1(2)SNG
Usage Guidelines
Use this command to enable syslog reporting of the status of the xconnect redundancy group.
Examples The following example enables syslog reporting of the status of the xconnect redundancy group and
shows the messages that are generated during switchover events:
Router# config t
Router(config)# xconnect logging redundancy
Router(config)# exit
Activating the Primary Member
00:01:07: %XCONNECT-5-REDUNDANCY: Activating primary member 10.55.55.2:1000
Activating the Backup Member:
00:01:05: %XCONNECT-5-REDUNDANCY: Activating secondary member 10.55.55.3:1001
Related Commands Command
xconnect
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-204
xconnect logging redundancy
no xconnect logging redundancy
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Description
Binds an Ethernet, 802.1q VLAN, or Frame Relay attachment circuit
to an Layer 2 PW for xconnect service and enters xconnect
configuration mode.
Chapter 1 CLI Command Reference
OL-26031-07