Cisco ASR 901 Command Reference Manual page 116

protocol (ATM)
protocol (ATM)
To configure a static map for an ATM permanent virtual circuit (PVC), switched virtual circuit (SVC),
or virtual circuit (VC) class or to enable Inverse Address Resolution Protocol (ARP) or Inverse ARP
broadcasts on an ATM PVC, use the protocol command in the appropriate mode. To remove a static map
or disable Inverse ARP, use the no form of this command.
Syntax Description
protocol
protocol-address
virtual-template
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-102
protocol protocol {protocol-address [virtual-template] | inarp} [[no] broadcast |
disable-check-subnet | [no] enable-check-subnet]
no protocol protocol {protocol-address [virtual-template] | inarp} [[no] broadcast
disable-check-subnet | [no] enable-check-subnet]
Choose one of the following values:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Destination address that is being mapped to a PVC.
(Optional) Specifies parameters that the point-to-point protocol over
ATM (PPPoA) sessions will use.
Note
arp—IP ARP
bridge—bridging
cdp—Cisco Discovery Protocol
clns—ISO Connectionless Network Service (CLNS)
clns_es—ISO CLNS end system
clns_is—ISO CLNS intermediate system
cmns—ISO CMNS
compressedtcp—Compressed TCP
ip—IP
llc2—llc2
pad—packet assembler/disassembler (PAD) links
ppp—Point-to-Point Protocol carried on the VC
pppoe—PPP over Ethernet
pppovlan—PPPoE over vlan
rsrb—remote source-route bridging
snapshot—snapshot routing support
This keyword is valid only for the PPP protocol.
Chapter 1 CLI Command Reference
OL-26031-07