Snmp Mib Rep Trap-Rate - Cisco ASR 901 Command Reference Manual

snmp mib rep trap-rate

snmp mib rep trap-rate
To enable the router to send REP traps and sets the number of traps sent per second, use the snmp mib
rep trap-rate command. To remove the traps, enter the no snmp mib rep trap-rate command.
Syntax Description
value
Command Modes
Global Configuration
Command History Release
15.1(2)SNG
Usage Guidelines
The snmp mib rep trap-rate command configures the switch to send REP-specific traps to notify the
SNMP server of link operational status changes and port role changes.
Examples
The example shows how to configure the switch to send REP-specific traps:
Router(config)# snmp mib rep trap-rate 500
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-192
snmp mib rep trap-rate value
no snmp mib rep trap-rate
Specifies the number of traps sent per second. The range is from 0 to 1000.
The default is 0 (no limit imposed; a trap is sent at every occurrence).
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Chapter 1 CLI Command Reference
OL-26031-07