Cisco ASR 901 Command Reference Manual page 145

Chapter 1 CLI Command Reference
set ip precedence (route-map)
To set the precedence value (and an optional IP number or IP name) in the IP header, use the set ip
precedence command in route-map configuration mode. To leave the precedence value unchanged, use
the no form of this command.
Syntax Description
number | name
Command Default
Disabled
Command Modes
Route-map configuration
Command History Release
15.1(2)SNG
Usage Guidelines
Table 1-4
values in the IP header. They are listed from least to most important.
Table 1-4
Number
0
1
2
3
4
5
6
7
You can set the precedence using either a number or the corresponding name. Once the IP Precedence
bits are set, other QoS services such as weighted fair queueing (WFQ) and Weighted Random Early
Detection (WRED) then operate on the bit settings.
OL-26031-07
set ip precedence [number | name]
no set ip precedence
(Optional) A number or name that sets the precedence bits in the IP header.
The values for the number argument and the corresponding name argument
are listed in
Modification
Support for this command was introduced on the Cisco ASR 901 router.
lists the values for the number argument and the corresponding name argument for precedence
Number and Name Values for IP Precedence
Name
routine
priority
immediate
flash
flash-override
critical
internet
network
Table 1-4 from least to most important.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
set ip precedence (route-map)
1-131