Synchronous Mode - Cisco ASR 901 Command Reference Manual

synchronous mode

synchronous mode
To configure the ethernet interface to synchronous mode, use the synchronous mode command. Use the
no form of the command to disable the configuration.
Command Default
Asynchronous mode.
Command Modes Interface configuration.
Command History Release
15.1(2)SNG
Usage Guidelines
This command is applicable to Synchronous Ethernet capable interfaces. The default value is
asynchronous mode.
Examples
This example configures the ethernet interface to synchronous mode:
Router(config-if)#synchronous mode
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-198
synchronous mode
no synchronous mode
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Chapter 1 CLI Command Reference
OL-26031-07