Cisco ASR 901 Command Reference Manual page 41

Chapter 1 CLI Command Reference
clock-port
Specifies the mode of a PTP clock port.
Syntax Description
name
port-role
Defaults This command is disabled by default.
Command Modes PTP clock configuration mode
Command History Release
15.1(2)SNG
Examples The following example shows how to configure a PTP clock port.
Router# config terminal
Router(config)# ptp clock ordinary domain 0
Router(config-ptp-clk)# clock-port SLAVE slave
Router(config-ptp-port)# transport ipv4 unicast interface loopback
Router(config-ptp-clk)# clock-source 8.8.8.1
Related Commands Command
ptp clock
OL-26031-07
clock-port port-name port-role
no clock-port port-name port-role
Specifies a name for the clock port.
Specifies the role of the clock port, which can be slave or master.
slave—Sets the clock port to PTP slave mode; the port exchanges timing
•
packets with a PTP master device.
master—Sets the clock port to PTP master mode; the port exchanges
•
timing packets with PTP slave devices.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Description
Creates a PTP clock instance.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
clock-port
1-27