show etherchannel
Examples
The following example shows how to verify the configuration:
Router# show etherchannel load-balance
EtherChannel Load-Balancing Configuration:
EtherChannel Load-Balancing Addresses Used Per-Protocol:
Non-IP: Source XOR Destination MAC address
IPv4: Source XOR Destination MAC address
IPv6: Source XOR Destination MAC address (routed packets)
Related Commands
Command
channel-group
channel-protocol
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-154
src-dst-mac
Source XOR Destination IP address (bridged packets)
Description
Assigns and configures an EtherChannel interface to an EtherChannel group.
Sets the protocol that is used on an interface to manage channeling.
Chapter 1
CLI Command Reference
OL-26031-07