Cpu Traffic Ppp Set Mpls Experimental Topmost - Cisco ASR 901 Command Reference Manual

cpu traffic ppp set mpls experimental topmost

cpu traffic ppp set mpls experimental topmost
To re-mark the CPU generated traffic from default value (MPLS EXP 6) to the desired EXP value for
QoS treatment, use the cpu traffic ppp set mpls experimental topmost command on the global
configuration mode. Use the no form of the command to revert to the default values.
Syntax Description
value
Command Default
None
Command Modes Global configuration (config)#
Command History Release
15.4(1)S
Usage Guidelines
This command is used to mark the CPU generated traffic transmitted through MLPPP Interface. It
enables the user to provide desired QoS treatment to CPU generated traffic. The valid values are from 0
to 7.
Examples This example shows how to re-mark the CPU generated traffic from default value to the desired MPLS
EXP value for QoS treatment on a Cisco ASR 901 series router:
Router# configure terminal
Router(config)# cpu traffic ppp set mpls experimental topmost 6
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-32
cpu traffic ppp set mpls experimental topmost value
no cpu traffic ppp set mpls experimental topmost value
Multiprotocol Label Switching (MPLS) EXP field in the topmost label
header. Valid values are 0 to 7.
Modification
This command was introduced on the Cisco ASR 901 Series Aggregation
Services Routers.
Chapter 1 CLI Command Reference
OL-26031-07