Service Instance - Cisco ASR 901 Command Reference Manual

Chapter 1 CLI Command Reference

service instance

To configure an Ethernet service instance, use the service instance command in Layer 2 VPN
configuration mode. To disable this configuration, use the no form of this command.
Syntax Description
id
service-type
Command Default None
Command Modes
Layer 2 VPN configuration (config-l2vpn)
Command History Release
15.1(2)SNG
Usage Guidelines You must provision a Multiprotocol Label Switching (MPLS) pseudowire before configuring an Ethernet
service instance in Layer 2 VPN configuration mode.
Examples The following example shows how to configure an Ethernet service instance on a Cisco uBR10012
router:
Router(config-l2vpn) # service instance 4095 ethernet
OL-26031-07
service instance id service-type
no service instance id service-type
Service instance ID. Integer from 1 to 4294967295.
Service type for the instance.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
service instance
1-121