Cisco ASR 901 Command Reference Manual page 105

Chapter 1 CLI Command Reference
action
Command Default All Supported Platforms
The default bc and be values are 4 ms.
Command Modes Policy-map class configuration (config-pmap-c)
Command History Release
15.1(2)SNG
OL-26031-07
(Optional) Action to take on packets. Specify one of the following keywords:
All Supported Platforms
• drop—Drops the packet.
• set-clp-transmit—Sets the ATM Cell Loss Priority (CLP) bit from 0
to 1 on the ATM cell and sends the packet with the ATM CLP bit set to 1.
• set-dscp-transmit new-dscp—Sets the IP differentiated services code
point (DSCP) value and sends the packet with the new IP DSCP value
setting.
set-frde-transmit—Sets the Frame Relay discard eligible (DE) bit from
•
0 to 1 on the Frame Relay frame and sends the packet with the DE bit set
to 1.
set-prec-transmit new-prec—Sets the IP precedence and sends the
•
packet with the new IP precedence value setting.
transmit—Sends the packet with no alteration.
•
policed-dscp-transmit—(Exceed and violate action only). Changes the
•
DSCP value per the policed DSCP map and sends the packet.
set-cos-inner-transmit value—Sets the inner class of service field as a
•
policing action for a bridged frame on the Enhanced FlexWAN module,
and when using bridging features on SPAs.
set-cos-transmit value—Sets the packet cost of service (CoS) value and
•
sends the packet.
set-mpls-exposition-transmit—Sets the Multiprotocol Label
•
Switching (MPLS) experimental bits from 0 to 7 and sends the packet
with the new MPLS experimental bit value setting.
set-mpls-topmost-transmit—Sets the MPLS experimental bits on the
•
topmost label and sends the packet.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
police (percent)
1-91