Offload Sampling - Cisco ASR 901 Command Reference Manual

Chapter 1 CLI Command Reference

offload sampling

To configure the sampling rate for the offloaded Ethernet Connectivity Fault Management (CFM)
session, use the offload sampling command in the Ethernet CFM service configuration mode. To
remove this configuration, use the no form of this command.
Syntax Description
value
Command Modes Ethernet CFM service configuration (config-ecfm-srv) #
Command History Release
15.4(3)S
Usage Guidelines This command is used to the modify sampling rate at which a packet will be punted to the CPU.
Examples The following example shows how to use the offload sampling value command:
Router # configure terminal
Router(config)# ethernet cfm global
Router(config)# ethernet cfm domain MD4 level 4
Router(config-ecfm)# service 1 evc evc1 vlan 99 direction down
Router(config-ecfm-srv)# continuity-check
Router(config-ecfm-srv)# continuity-check interval 3.3ms
Router(config-ecfm-srv)# offload sampling 6000
Related Commands Command
ethnernet cfm global
ethernet cfm domain
level
continuity-check
OL-26031-07
offload sampling value
no offload sampling value
Sampling rate for the offloaded CFM sessions. The range is from 5000 to
65,535. The default value is 20,000.
Modification
This command was introduced on the Cisco ASR 901 Routers.
Description
Enables Ethernet CFM globally on a router.
Defines a CFM maintenance domain at a particular maintenance level.
Enables sending and receiving of continuity check messages.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
offload sampling
1-87