Interface Port-Channel - Cisco ASR 901 Command Reference Manual

interface port-channel

interface port-channel
To create an EtherChannel interface, use the interface port-channel command in global configuration
mode. To remove this EtherChannel port from the Cisco CMTS, use the no form of this command.
Syntax Description
number
Command Default
By default, EtherChannel groups and ports are not defined, and they are disabled (off mode) configured.
Command Modes Global configuration
Command History Release
15.1(2)SNG
Usage Guidelines The first EtherChannel interface configured becomes the bundle master for all EtherChannel interfaces
in the group. That is, the MAC address of the first EtherChannel interface is the MAC address for all
EtherChannel interfaces in the group. If the first EtherChannel interface is later removed, the second
EtherChannel interface to be configured becomes the bundled master by default.
Repeat this configuration on every EtherChannel port to be bundled into a FastEtherChannel (FEC) or
GigabitEtherChannel (GEC) group. This configuration must be present on all EtherChannel interfaces
before the EtherChannel group can be configured.
Examples The following example configures the port to have an EtherChannel port number of 1 within its
EtherChannel group. The EtherChannel group is defined with the channel-group command.
Router(config)# interface port-channel 1
Related Commands Command
channel-group
show interface
port-channel
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-52
interface port-channel number
no interface port-channel number
Identifying port channel number for this interface (EtherChannel port). The
range is 1 to 8.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Description
Assigns an EtherChannel port to an EtherChannel group.
Displays the EtherChannel interfaces and channel identifiers, with their
mode and operational status.
Chapter 1 CLI Command Reference
OL-26031-07