Table of Contents
Advertisement
Attaching the hooks (for CS1000EV and CS1100EV with stand *)
(1) Hook the rear of the hooks provided over the center bar of the stand. (Refer to diagram below.)
(2) Store the document hold-down unit EV by mounting it on the hooks with its handles opened outward.
* The CS1100EV stand is optional.
Replacement method
Detach the document hold-down unit currently fitted and replace it with the document hold-down unit EV.
(Refer to sections 8.2, "Document Hold-down Unit". )
Distance correction method
Distance correction can be performed via the driver software. In the ScanningMaster 21+ driver software
provided, run distance correction from the "Tools/Scanner Adjustment" menu to adjust the scanning preci-
sion.
CHECKPOINT
The handles at both ends of the document hold-down unit EV are silver, whereas the handles at the ends of the
standard document hold-down unit are black. Take care to ensure that the correct document hold-down unit is used.
The document hold-down units are symmetrical and can be fitted either way round. However, they are factory
adjusted, and installing left-to-right may cause paper jamming.
Always check the directions indicated by labels on the document hold-down units and scanner when installing.
Insert the document hold-down unit fully. If the document hold-down unit is not fully down, it will cause reduced
image quality or paper jamming.
CS1000-UM-251-03-9370
3. PREPARING TO OPERATE THE SCANNER
Document hold-down unit EV
3-11
Hooks
Advertisement
Table of Contents
