Pulleys; Adjusting The Tension Belt - GRAPHTEC CS1000 Service Manual

8.21 Pulleys

Disassembly procedure
8.2
p.8-2
Detaching the document
hold-down unit
Detaching the pulleys
(1) Loosen the two silver M4L10TP screws securing the motor and detach the tension belt.
(2) Loosen the set screws and remove the pulleys.
Reattaching the pulleys
(1) Reattach the pulleys by reversing the sequence of steps in which they were detached.
(2) Push each pulley as far as it will go and secure with the set screw.

Adjusting the Tension Belt

See the previous page.
CS1000-UM-251-03-9370
8. DISASSEMBLING AND ADJUSTING MECHANICAL PARTS
8.4
p.8-5
Detaching the side cover
(the left-hand side cover only)
Tension belt Tension belt
Motor Motor
Pulleys Pulleys
M4L10TP screws M4L10TP screws
Set screws Set screws
8-28
This Section
Detaching the pulleys