Bottom Plates, Large And Small - GRAPHTEC CS1000 Service Manual

8.8 Bottom Plates, Large and Small

Disassembly procedure
8.2
p.8-2
Detaching the document
hold-down unit
Detaching the bottom plates, large and small
(1) Remove the three silver M3L6TP screws while supporting the large bottom plate with one hand.
(2) Remove the four silver M3L6TP screws while supporting the small bottom plates (left and right sides)
with one hand.
CAUTION
Support the bottom plates to keep them from dropping when the screws are removed.
Reattaching the bottom plates
(1) Reattach the bottom plates in the reverse order in which they were detached.
(2) Make sure the ventilating openings face forward when reattaching the bottom plates.
CAUTION
The attachment direction of the small bottom plates is specified by UL standard. Special care must be taken to
attach the panel correctly.
CS1000-UM-251-01-9370
This Section
Detaching the bottom
plates, large and small
Front Front
Bottom plate, small (left side) Bottom plate, small (left side)
Front Front
M3L6TP screws
8. DISASSEMBLING AND ADJUSTING MECHANICAL PARTS
Bottom plate, large
M3L6TP screws
Bottom plate, small (right side) Bottom plate, small (right side)
M3L6TP screws
8-9
Front Front