Table of Contents
Advertisement
RIP Enable
RIP Trust Neighbors
RIP Interval
RIP Domain
OSPF Enable
OSPF Router ID
RIP Parameters
Globally enables RIP 1, RIP 2, or No RIP.
Values: Disable, Enable RIP1, Enable RIP2
Default: Enable RIP2
Globally enables the trusted neighbors feature. If there is a list of trusted
neighbors in an IP Gateway, only RIP packets coming from those trusted
neighbors will be used to build the internal routing table.
Values: Enable, Disable
Default: Enable
Interval for RIP packet to be sent. Default is 30 seconds.
Value representing the RIP domain. Default is 0.
OSPF Parameters
Globally enables OSPF.
Values: Disable, Enable
Default: Disable
This 32-bit number assigned to each router running the OSPF protocol
uniquely identifies the router within an Autonomous System. Each router
requires a unique router ID. Default is the LAN IP address of the unit.
The IP Gateway screen provides the following user-activated buttons:
Button
RIP Parameters
Static Route Table
Static ARP Table
Trusted Neighbors
OSPF Parameters
Area Table
Virtual Link Table
Submit
Circuit Table
Circuit Table Screen
Access this menu by clicking on the "Circuit Table" button at the bottom of the
IP Gateway Details screen. The Circuit Table shows the configured circuit. To
configure a new circuit, click on "Add New."
Function
Displays static routes and dynamic routes information.
Displays static ARP information.
Displays trusted neighbors information.
Displays area information.
Displays virtual link information.
Submits to the unit information specific to IP Gateway.
Lets you access to circuit-related information/operation.
W e b S e r v e r I n t e r f a c e
3-49
Advertisement
Table of Contents
