Table of Contents
Advertisement
Speed
Character Size
Parity
Stop Bit
DTR Alarm Control
DTR Alarm Status
Diagnostic Messages
Current Pin Status
4-14
T 1 A c c e s s R o u t e r
Figure 4.13
Supervisory Screen
Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Sets the parity bit.
Values: None, Odd, Even
Default: None
Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Lets you set DTR Alarm Control parameters. Selecting "Enable" allows the
unit to go into alarm on loss of DTR, which occurs when the Supervisory port
detects that the DTR signal is low.
Values: Enable, Disable
Default: Disable
Lets you view the current DTR Alarm status.
Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Supervisory interface screen.
Advertisement
Table of Contents
