Verilink T1 Reference Manual page 127

N3
T1
Tx Threshold
Tx Alarm
Rx Threshold
Rx Alarm
Default CIR (bps)
Default Be Rate (bps)
Enforce CIR and Be
Represents a Monitored Events Count. For a network, a monitored event is
the receipt of a status inquiry message or the expiration of the polling
verification timer T2. For a FRAD, a monitored event is the transmission of a
status inquiry message. This parameter defines the size of the sliding window
used by the unit to determine whether a channel or user device is active.
Values: 5–255
Default: 4
Specifies the number of seconds the unit waits between issuing status enquiry
messages.
Values: 5–30
Default: 10
Number of bits per second sent during a 15-minute interval after which a Tx
alarm will be triggered. A value of "0" (zero) disables this trap.
Values: 0–4294967295
Default: 0
Status of this alarm (OK, Alarmed).
Number of bits per second sent during a 15-minute interval after which an Rx
alarm will be triggered. A value of "0" (zero) disables this trap.
Values: 0–4294967295
Default: 0
Status of this alarm (OK, Alarmed).
The Committed Information Rate (in bits per second) provided by your frame
relay service provider. The unit will apply this value to each DLCI learned
from the network side to gather statistics and to perform CIR enforcement, if
required. If a DLCI is configured with a CIR different from the default, the
DLCI configuration will be used instead.
Values: 0–1536000
Default: 0
The Excess Burst Rate (in bits per second) provided by your frame relay
service provider. The unit will apply this value to each DLCI learned from the
network side to gather statistics and to perform CIR enforcement, if required.
If a DLCI is configured with an Excess Burst different from the default, the
DLCI configuration will be used instead.
Values: 0–1536000
Default: 0
If this parameter is set to "Yes," the unit will enforce Committed Information
Rate and Excess Burst.
Values: No, Yes
Default: No
V T 1 0 0 I n t e r f a c e 4-19