Endpoint Details Screen - Verilink T1 Reference Manual

3-30 T 1 A c c e s s R o u t e r
The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database only after at least one endpoint parameter has been
changed and submitted in the Endpoint Details screen (page 3-30).
NOTICE:
The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database only after at least one endpoint parameter has
been changed and submitted in the Endpoint Details Screen on
page 3-31. When in IP Gateway, if you decide to use a "discovered"
endpoint, you must rename it. A discovered endpoint cannot be used
elsewhere (i.e., IP Gateway) until it has been renamed. Also, it will not
be saved in the configuration database.
NOTICE:
Endpoint names of the form PPP-Sn are reserved by the system. These
system-generated endpoints cannot be modified.
Figure 3.25 Endpoint Table Screen
For most applications, you will not have to modify the Endpoint Table and
DLCI Table. Modification is necessary, however, to configure remote in-band
management. (See In Band Management on page 3-34.)

Endpoint Details Screen

The Endpoint Details screen (Figure 3.26). which you access by clicking on
an Index number on the Endpoint Table, lets you access the configuration
parameters described in the paragraphs below.