Password - Verilink T1 Reference Manual

Password

•
Save the configuration setup of a T1 Access Router unit
•
Restore a saved configuration setup to a T1 Access Router unit
To transfer a file to or from a TFTP server from a T1 Access Router unit, you
must indicate the TFTP server's IP address, the file name, and then perform a
Get operation to receive a file from the server, or a Put operation to send a
file to the server. The file name and its extension determine the type of file
transferred.
The table below shows the possible file operations.
Operation
Update Application Firmware
Update Boot Firmware
Save Configuration Setup
Restore Configuration Setup
Note that when updating the application software using a .HEX file, the
filename should have the form xxAPxxxx.HEX; the AP indicates the file is
an application load. When updating the boot software, the filename should
have the form xxWBxxxx.HEX; the WB indicates the file is a boot load.
The Password Details screen (Figure 3.79) is used to modify the password
that restricts access to the Web Server interface.
Acceptable characters for use in a password are digits 0–9 and letters A–Z
and a–z, for a total of 62 distinct characters.
Figure 3.79 Password Details Screen
To change either the Admin or Read-Only password, you must enter it once
in the New Password field and then re-enter the same password in the
Confirm Password field. After entering the new password in both these fields,
click the "Change Admin Password" or the "Change Read Only Password"
button to update and establish the new password.
Filename Extension
.CHX or .HEX(1) Get
.HEX(2) Get
.CFG Put
.CFG Get
W e b S e r v e r I n t e r f a c e
Action
3-79