Table of Contents
Advertisement
IP Address
Subnet Mask
Gateway IP Address
DHCP Client
Client Identifier
Physical Address
4-12
T 1 A c c e s s R o u t e r
Figure 4.10
IP Details Screen
A unique Network address assigned to this unit.
Defines the Network portion of the unit's IP address.
IP address of the default gateway (router) on the LAN side of the unit.
If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
NOTICE:
Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
Displays a unique identifier for a specific IP address.
Displays unique MAC address.
NOTICE:
If you manually change the IP address, you must "Save and Restart."
(See Save and Restart on page 4-6.)
Select the Unit Access Table prompt on the Ethernet (IP Details) screen to
view the Unit Access Table (Figure 4.11), which specifies up to 10 different
IP networks that may access the unit. If no IP networks are supplied, any host
can access the unit. Select an <Ndx> number on the table to view the Unit
Access Details (Figure 4.12) that correspond with that number.
Advertisement
Table of Contents
