Dhcp Server Details Screen - Verilink T1 Reference Manual

Enable
Number of Ports
TTL
Service Type
Lease Time
Primary DNS IP Addr
Secondary DNS IP
Addr
Domain Name
Router IP Addr
Primary WINS IP
Addr
Secondary WINS IP
Addr

DHCP Server Details Screen

The DHCP Server Details screen (Figure 4.66) lets you configure the
parameters described below.
Figure 4.66 DHCP Server Details Screen
Enables or disables the DHCP Server. Default is "Disable."
Defines the number of DHCP ports to be used. In this version, only "1" is a
valid value.
Time to Live for any DHCP packet. Default is 64.
Type of Service used by the DHCP Server packet. Default is 1.
Tells the DHCP client the number of seconds it can retain this IP address. The
client should make a new DHCP request within the specified amount of time
to ensure the IP address is not given to another PC. Default is 600 seconds.
If requested by DHCP client, the client then uses this address to resolve
names of IP addresses. Default is 0.0.0.0.
If requested by DHCP client, the client then uses this secondary address to
resolve names of IP addresses. Default is 0.0.0.0.
Domain name to be used by all DHCP clients. Default is user's server.
IP address that all clients use for Gateway or Router. Default is 0.0.0.0.
If requested by DHCP client, the client then uses this address to resolve
names of IP addresses. Default is 0.0.0.0.
If requested by DHCP client, the client then uses this secondary address to
resolve names of IP addresses. Default is 0.0.0.0.
V T 1 0 0 I n t e r f a c e 4-69