Verilink T1 Reference Manual page 160

Endpoint
Target IP Address
Target IP Mask
Next Hop IP Address:
Cost
Route Status
4-52 T 1 A c c e s s R o u t e r
Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Represents the target network that you want this router to reach.
Mask of the target network.
NOTICE:
Setting the target IP address and Target IP Mask to 0.0.0.0 defines THE
default route for this unit.
IP address of the next device in the route.
Cost of using that route.
Indicates whether this route is enabled or disabled.
Dynamic Route Table Screen
Access this menu by selecting the "Static Route Table" on the IP Gateway
menu and then selecting Dynamic Route Table. This table shows both
dynamic and circuit tables. Please note that not all parameters are necessarily
defined, depending on whether or not the routes were learned dynamically.
Primarily, the most useful information is included in "Destination," "If Ndx,"
and "Mask" columns.
Figure 4.44 Dynamic Route Table Screen
The Dynamic Route Table displays the fields listed below.
Field Description
Destination Network to be reached.
If Ndx Internal TCP/IP stack interface number.
Next Hop IP address used to reach the destination network.
Mask Mask of the destination network.