Static Routes Screen - Verilink T1 Reference Manual

Endpoint
Target IP Address
Target IP Mask
Next Hop
Cost
Route Status
3-52 T 1 A c c e s s R o u t e r
The Circuit Details screen provides the following user-activated buttons:
Button Function
Submit Sets any values that have been changed.
Circuit Table Returns you to the previous screen.

Static Routes Screen

Under some circumstances, it may not be necessary for a router to learn a
route using ordinary means such as RIP or OSPF. It is possible under these
circumstances for you to add a route to the route table of a router.
The Static Route Table is always associated with a circuit. Access this screen by
selecting the Static Route Table from the RIP Parameters Table on the IP
Gateway Details screen.
Figure 3.41 Static Route Table Screen
Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Represents the target network that you want this router to reach.
Mask of the target network.
IP address of the next device in the route.
Cost of using that route.
Indicates whether a route is enabled or disabled.
The Static Routes Table screen provides the following user-activated buttons:
Button
Dynamic Route Table
Add New
Route Details Screen
Access this menu by clicking on the appropriate number under the "Index"
column on the Static Route Table screen.
Function
Displays routes learned via RIP or OSPF.
Adds a new static route.