Table of Contents
Advertisement
Round Trip Delay
Round Trip Rate
Status
Receiving FECN/
BECN
CIR Threshold
CIR Alarm
Bits Over Be Threshold
Bits Over Be Alarm
Congestion Threshold
Congestion Alarm
BECN in CIR
UAS Threshold
UAS Alarm
4-34
T 1 A c c e s s R o u t e r
Specifies the frame size (in bytes) of packets making round-trip.
Specifies the rate (in seconds) at which Round Trip Delay packets are sent.
DLCI Status Table
The bottom portion of the screen shows a table detailing the actual status of
this DLCI and alarm threshold information as follows:
If this DLCI is up, the status will be "Active"; otherwise, the status will be
"Inactive."
Values: Active, Inactive
Default: Inactive
When a frame is received with congestion bit set, this parameter is set to
"Yes." It is set back to "No" when a frame is received without congestion bit
set.
Values: Yes, No
Default: No
Sets the Tx over CIR alarm threshold. This threshold is the number of bits per
second in excess of CIR during a 15-minute interval. Setting this field to "0"
(zero) disables the alarm.
Reports if the Tx over CIR threshold has been exceeded.
Sets the Tx over the excess burst (Be) alarm threshold. This threshold is the
number of bits per second in excess of CIR + Be during a 15-minute interval.
Setting this field to "0" (zero) disables the alarm.
Reports if the Tx over Be threshold has been exceeded.
Sets the Rx Congestion alarm threshold. This threshold is the number of
frames received with BECN/FECN. Setting this field to "0" (zero) disables
the alarm.
Reports if the Rx Congestion threshold has been exceeded.
Reports if Backward Explicit Congestion Notification (BECN) has been
received within CIR.
Sets the Unavailable Seconds (UAS) alarm threshold. This threshold is the
number of seconds after which the DLCI is unavailable. Setting this field to
"0" (zero) disables the alarm.
Reports if the UAS threshold has been exceeded.
Advertisement
Table of Contents
