Verilink T1 Reference Manual page 141

Bc (bps)
Discard Eligible Flag
In Band Management
FrameStart Delay
FrameStart Status
Remote DLCI
Remote Unit
Remote IP Address
If CIR enforcement is configured to "Yes," the unit will throttle the
Committed Burst down to this value (in bits per second) when frames are
received with the BECN bit set.
Values: 0–1536000
Default: 0
If this parameter is set to "Yes," and CIR enforcement is also set to "Yes," the
unit will set the Discard Eligible (DE) bit for frames sent over CIR.
Values: Yes, No
Default: No
If the unit is to be used as a gateway to reach a remote T1 Access Router
through this DLCI, set this parameter to "Yes," and configure the remote IP
address and Mask in the corresponding endpoint.
Values: Yes, No
Default: No
If this parameter is set to "Enable," the unit will send FrameStart discovery
and delay frames on this DLCI, and will report the state of the remote
Verilink FSx unit. It will also send SOS frames when the FRAD/router
connected to this unit goes inactive.
Values: Enable, Disable
Default: Enable if Auto Discovery is set to "Yes"; otherwise Disable
If the remote unit is a Verilink FSx product and FrameStart Auto Discovery is
enabled, the FrameStart Status field will show the status of the remote unit.
The status is "Active" if both the local and remote DLCIs are active and the
remote unit answers to the discovery frames sent by this unit. The status is
"SOS" if the remote unit is active but the FRAD/router connected to it is
inactive. The status is "Inactive" in all other cases.
Values: Active, Inactive, SOS
Default: Inactive
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery is
enabled, this field displays the DLCI number used on the remote end of this
DLCI.
Values: 16−1023
Default: 0
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery is
enabled, this field displays the first three digits of the unit ID configured on
the remote end of this DLCI.
Values: 000−999
Default: 000
Displays the IP address of the unit configured on the remote end of this
DLCI.
V T 1 0 0 I n t e r f a c e 4-33