Trap Log - Verilink T1 Reference Manual

Elapsed Time
Bit Errors
Errored Seconds
%EFS

Trap Log

4-44 T 1 A c c e s s R o u t e r
"No Sync" is displayed. If the receiver is in pattern sync, "In Sync" is
displayed.
Displays the time elapsed since a timed test began or, if completed, the total
test time.
Displays the total number of bit errors detected since the test began or since
error statistics were cleared.
Displays the number of asynchronous errored seconds that have been detected
since the test began or since error statistics were last cleared.
Displays the percentage of time that the test ran error-free. This ratio is
derived from the number of error-free seconds divided by the number of
seconds accumulated in Elapsed Time.
Loop Table
The Loop table lets you specify the type of Loop test to be performed. The
types of tests available for you to choose from depend on the currently
selected interface.
Values: No Test (Loop Down), payload loopback (PLB), line loopback
(LLB), maintenance loopback (MLB), Far PLB, and Far LLB
Default: No Test (Loop Down)
The Test Details screen provides the following user-selectable prompts:
Prompt Function
Start BERT Starts the specified BERT.
Stop BERT Stops the currently running BERT.
Error Inject Injects a bit error.
Reset Errors Resets the current error count.
The Trap Log screen (Figure 4.37) shows a collection of all the traps that
have been generated. A trap is a mechanism that permits a device to send an
alarm for certain network events to an SNMP management station.
The table shown in this screen lists each trap by its Index number, and
displays the type of error captured by the trap (Trap Number) and the date and
time that the trap was stored (Time Stamp).