Snmp Trap Configuration - Verilink WANsuite 5330 Reference Manual

SNMP Trap Configuration

Generic MIB Loading Instructions
B-2 W A N s u i t e 5 3 3 0
rfc2863.mib − describes generic objects for network interface sub-layers
•
(This MIB is an updated version of MIB-II's ifTable, and
incorporates the extensions defined in RFC 1229.)
rfc2493.mib − provides textual conventions to be used by systems
•
supporting 15-minute based performance history counts
rfc2115.mib − describes the use of a Frame Relay interface by a DTE
•
rfc2495.mib − describes DS1, E1, DS2 and E2 interfaces objects
•
rfc2011.mib − for managing IP and ICMP implementations, but excluding
•
their management of IP routes
rfc2012.mib − for managing TCP implementations
•
rfc2013.mib − for managing UDP implementations
•
rfc2096.mib − for the display of CIDR multipath IP routes
•
rfc2571.mib − the SNMP Management Architecture MIB
•
The WANsuite 5330 supports the following Enterprise-specific MIBs:
ds8200tc.mib − textual conventions used by DS8200 MIB
•
ds8200v2.mib − provides T1 configuration and statistics information
•
− provides Frame Relay, PPP, and Service Aware
•
ipadv2.mib
configuration and statistics
− MIB module for synchronous PPP
•
ipstart.mib
− provides configuration of OSPF router
•
router.mib
− MIB module for HDSL
•
hdsl2.mib
These MIB files may be found on the Verilink Documentation CD included
with the unit.
The WANsuite 5330 supports up to eight IP destinations for SNMP traps.
These may be configured either through the Web interface or through an
SNMP management application. For configuration of these destinations
through an SNMP management application, use a MIB browser to access the
table trapdest within ipadv2.mib and set the IP addresses of the host
computer running the management application(s). Entering an IP address of
0.0.0.0 will disable the entry.
The MIBs were written using the standard ASN.1 notation. Any standard SNMP
manager should be able to compile the MIBs. Although the exact procedure for
loading MIBs may vary from one platform to another, the following basic steps
are the same.
1
The SNMP manager has a directory for MIBs. Copy the files
ds8200tc.mib , ds8200v2.mib , ipadv2.mib , ipstart.mib ,