Figure 69 Fake Power Supply Module - Zte ZXR10 8900 Series Hardware Installation Manual

1. Hold both sides or hold the bottom of the power module guard
2. Pull the guard upward and remove it. Loosen the captive screw
3. Hold the plastic guard of the module and pull it outward forcibly
Result: Power module of ZXR10 8902 has been unplugged.
Fake power supply module is required in the case of no three power
Install and
Remove Fake supply modules, which consists of installation plate, metallic-rect-
Power Supply
angular frame, fake power supply module cover and power module
Module
guard, as shown in
F
IGURE
1.
2.
�
with hands.
on the bottom side of the module.
until it is pulled out.
Figure
69 F P S
AKE OWER
Installation plate
Metallic-rectangular frame
Install fake power supply module
To install fake power supply module, the necessary space
needs to be left for using screwdriver. Therefore, fake power
supply module shall be installed before plugging card, or
unplug the card before installation. Plug the fake power supply
module into its corresponding module slot and remove the
power guard, as shown in
and fixed screw (M3 × 8).
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 Master Device Installation
69.
M
UPPLY ODULE
3. Fake power supply module cover
4. Power module guard
Figure 70. Fasten captive screws
73