ZXR10 8900 Series Hardware Installation Manual
Labels Pasted on
Cables
92
Confidential and Proprietary Information of ZTE CORPORATION
bel affects the cable's appearance. This is pasted on cable through
the self-contained cellulose tape.
�
Power Cable Label
A flag-like label worked out by ZTE can be used as an engi-
neering marker for power cables, as shown in
F
86 S
IGURE
CHEMATIC
The paste position is 2cm away from the lug. First paste the
label on the cable for less than a half circle and then stick the
backs of the two half parts of the flag-type label. One such
label must be pasted on each end of a power cable, as shown
in
Figure
87.
F
87 P
IGURE
ASTING
The flag-like power cable is divided into two areas: L and R.
Their specific meanings are as follows:
L: On this place, location code of local equipment must be
�
filled. That is, it indicates the location of local equipment
connected with power cable.
R: On this place, the location code of remote equipment
�
must be filled. That is, it indicates the location of remote
equipment connected with the power cable. If it is a power
distribution cabinet at the other end, the distribution cab-
inet and the nature of the power cable must be indicated.
For example: Distribution GND.
D
P
IAGRAM OF A
OWER
P
P
C
OSITION OF
OWER
Figure
86.
C
L
ABLE
ABEL
L
ABLE
ABELS