A C p o w e r
The Mania SCX500 is supplied set up to match local voltage and
frequency. The factory setting is shown on the serial number label. It is not
possible to reconfigure the Mania SCX500 to accept any other voltage or
frequency than those stated on the serial number label.
For protection from fire and electric shock, the fixture must be
grounded (earthed). The power supply must have overload
and ground-fault protection.
Check that power cables are undamaged and rated for the
current requirements of all connected devices before use.
Check the operating voltage and frequency indicated on the
serial number label before applying power. If your Mania
SCX500 does not match your local AC power, do not use it.
Important! Do not connect the fixture to a dimmer system.
Installing a plug on the power cable
The power cable must be fitted with a grounding-type (earthed) power
plug that matches your power distribution system. Consult a qualified
electrician if you have any doubts about proper installation.
If you need to fit a power plug, follow the plug manufacturer's instructions,
connecting the yellow and green wire to ground (earth), the brown wire to
live, and the blue wire to neutral. The table below shows some pin
Table 1: Power plug wiring
yellow or brass