Table of Contents
Advertisement
• Replace the lamp if it becomes defective or worn out. When replacing the lamp,
allow the fixture to cool for at least 15 minutes before opening the fixture or
removing the lamp. Protect your hands and eyes with gloves and safety glasses.
• Never place filters or other materials over the lenses or mirror drums.
• Allow the fixture to cool for 15 minutes before handling.
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
To prot ect yoursel f and ot hers fr om inj ur y due t o f alls
• When suspending the fixture above ground level, verify that the structure can hold
at least 10 times the weight of all installed devices.
• Verify that all external covers and rigging hardware are securely fastened and use
an approved means of secondary attachment such as a safety cable.
• Block access below the work area whenever installing or removing the fixture.
L A M P I N S T A L L A T I O N
Use only the lamp specified for your model.
Model
Wheeler EU
Wheeler UK
Wheeler US
Warning!
Make sure the fixture is disconnected from AC power before
removing the lamp box. Allow hot lamps to cool for 15 minutes
before replacing.
1 Locate the lamp box with the four lenses in the center of the unit. Support it in
one hand while removing the two thumbscrews on the top, and remove the
lamp box.
2 Hold the lamp by the ceramic base or in a clean cloth, taking care not to touch
the glass, and then push the lamp firmly into the lamp socket. If you do touch
the glass part of the lamp you must clean it thoroughly with alcohol before
use.
3 As you replace the lamp box, lead the wires through the corner opening so as
not to pinch them. Replace the thumbscrews and tighten them securely by
hand.
4
Lamp
300W/230V
300W/240-250V (M38) 5200 lm, 2000 h
300W/120V (DRA)
Output/Life
7300 lm, 50 h
7700 lm, 75 h
www.audiovias.com
Martin P/N
97000203
97000200
97000201
Advertisement
Table of Contents
