Table of Contents
Advertisement
Physical installation
Warning! Read 'Safety information' on page 5 before installing the fixture.
Contact your Martin® supplier for assistance if you have any questions about how to
install this product safely.
Fixture location
Exterior Wash Pro family fixtures are intended for outdoor use. With an IP66 rating, they are protected
against dust, humidity and water and are able to withstand powerful water jets, but they are not
submersible.
Mounting the fixture
The fixture and yoke can be mounted at any angle. The yoke allows the fixture to be manually panned
and tilted for beam aiming adjustment.
The fixture and mounting bracket are manufactured in corrosion-resistant anodized aluminum. Avoid
mounting the fixture in direct contact with other types of metal, as this can cause galvanic corrosion.
When fastening to a dissimilar metal surface:
•
Use an electrically insulating material (such as rubber or plastic) or coating between the mounting
bracket and the other metal.
•
Use a non-conductive coating such as Delta Seal on fasteners (screws, bolts, washers, etc.)
where they come into contact with the mounting bracket.
The fixture's mounting yoke base must be securely and safely anchored to a stable, static surface,
pedestal, structural beam, rigging truss or other suitable support. Do not stand the fixture unanchored
on a surface or leave it where it can be moved or fall over.
Mounting on a surface
To anchor the mounting yoke to a wall or other flat surface, use at least three high-strength corrosion-
resistant fasteners that are safe for the application and the environment (recommended minimum
properties: stainless steel A4-70 grade according to ISO 3506 or steel grade 8.8 according to
ISO 898-1). Any nuts used must be self-locking. Install washers under all nuts and bolt heads. Make
sure that there is a washer between each fastener and the yoke base.
To mount L and XL fixtures on a suitable surface:
1. See Figure 1. Pass a 12 mm (1/2 inch) shaft diameter bolt through the 13.5 mm hole in the center
of the yoke base and fasten it finger-tight into the surface.
®
Martin
Exterior Wash Pro family Safety and Installation Manual Rev. A
Figure 1. Mounting yoke base, S and M fixtures
11
Advertisement
Table of Contents
