Download  Print this page

Auto Trig Operation; Music Trig Operation - Martin Mania SCX500 User Manual

Mania scx500
Hide thumbs

Advertisement

Selecting op erating modes
To switch between DMX, auto trig and music trig modes:
1. Apply power to the fixture. If the
0 0 1
display shows
the fixture is in DMX mode with DMX
address 001.
2. Press the Mode button once. The
fixture enters auto trig mode and
9 0 0
appears in the display.
3. Press the Mode button again once.
The fixture enters music trig mode,
901
and
appears in the display.
4. Press the button again once to return
to DMX mode. The fixture's DMX
address appears in the display.
5. Repeat this procedure to continue
scrolling through operating modes.
When a fixture is powered off and then on again, it will remember which
mode it is set to and start up in that mode.
A u t o t r i g o p e r a t i o n
In auto trig operation, the Mania SCX500 runs a factory-set dynamic light
show that uses all the fixture's effects in a random program
M u s i c t r i g o p e r a t i o n
In music trig stand-alone mode, the Mania SCX500 runs a dynamic light
show in time with a music beat. Sensitivity can be adjusted for optimum
synchronization with the music.
To adjust sensitivity:
1. Power the Mania SCX500 on.
2. Play a typical music track at
typical volume for the location.
3. Use the sensitivity knob to
adjust the sensitivity until the
desired level of light effects is
obtained.
after it has reset,
Operation
Mode selection
DMX Address
X100
X10
X1
Mode button
Music trig sensitivity
setting
Mode
15

Hide quick links:

Advertisement

loading

  Also See for Martin Mania SCX500