When The Message [Replace Wiper] Is Displayed [Wiper Exchg] - MIMAKI Tx2-1600 Operation Manual

When the message [Replace Wiper] is displayed [WIPER EXCHG]

The wipers are consumable parts. As the wiper continues cleaning the head, it gets stained
with ink and dust. The printer counts the number of times the wipers are cleaned and tells
when to replace them. When the message [Replace Wiper] is displayed, replace the wiper
with a new one without delay. When replacing the wiper, remove ink adhered at the bottom
surface of the slider.
The message [Replace Wiper] is displayed while the printer
is in operation or when the printer power is switched on.
When the message is displayed, replace the wipers with new
ones.
• The wiper is separately available from your local distributor or our office.
• Do not press the [ENTER] key other than the case of replacing wipers. The
number of wiper operations that is counted in the printer will be reset. Do not
select [Replace Wiper] unless the wiper is to be really changed.
STEPS:
1. Select [STATION] from [MAINTENANCE].
(See page 4.3)
2. Press the [ENTER] key.
3. Press the JOG keys [ ] and [ ] to select [WIPER
EXCHG].
4. Press the [ENTER] key.
The carrige will come out of the capping station.
5. Open the maintenance cover to change the wiper.
6. Holding the projections at both ends, draw out
the wiper.
Use the gloves that are supplied with the separately-available
cleaning wiper to protect your hands from stains.
- 4.11 -
W i p e r
R e p l a c e W i p e r
M A I N T E N A N C E
S T A T I O N < e n t >
S T A T I O N M A I N T
M A I N T : CA R R I AGE ou t
S T A T I O N M A I N T
M A I N T : W I P ER E XCHG
W I P ER E XC H ANGE
C OM P L E T E D : en t