When The Ink Remain Setting Message Is Displayed - MIMAKI JV400-130LX Operation Manual

When the INK REMAIN Setting Message is Displayed

If the remaining amount of ink inside the cartridge falls below a specified level when [SET UP] in INK REMAIN of
MACHINE SETUP is set to "ON" (
When the message appears, perform the following steps to adjust the ink cartridge weight.
Please prepare your scale (which can weigh up to 1200g in 1g).
1
Press the
MAINT.
• The slot with the ink cartridge for which you need to register the
weight is selected automatically.
2
Weigh the ink cartridge on the scale.
• Attach the IC chip and the ink pack when weighing.
3
Press
checked at the Step 2.
4
Press the
5
Check the weight and press the
• If there are other slots for which the weight registration is necessary, each slot is automatically
numbered. Repeat steps 2 to 4.
• If there are no more slots where the weight registration is necessary, you will automatically return to
LOCAL.
P.3-31), a warning message appears on the display.
key in LOCAL.
to enter the weight of cartridge
key.
S L OT 1
I NK REMA I N = 8 0 0 g
S L OT 1
I NK REMA I N = 8 0 0 g
S L OT 1
8 0 0 g OK ?
key.
Troubleshooting
[ EN T ]
5-7
1
1
1
1
5