Switching On/Off The Power Supply; Turning The Power On - MIMAKI Tx2-1600 Operation Manual

Switching ON/OFF the power supply

After setting up the printer, switch on and off the power as described below.

Turning the power on

STEPS:
1. Turn on the power to the computer, etc. that are
connected to the device.
2. Turn on the power to the printer.
Tilt the power switch toward the " I "side, and the power to the
printer is turned on.
• At this time, the front cover must be closed.
With the front cover kept open, the carriage
does not move even when the power is
switched on.
When the power is switched on, the LCD first displays [BOOT]
and then displays the firmware version number.
The message "PLEASE WAIT" appears flashing on the LCD.
The menu enters the LOCAL mode.
• If a fabric has been set on the printer, the
prompt [MEDIA SELECT] is displayed on the
LCD when the power is switched on.
After selecting media , the printer detects the
media and returns to the LOCAL mode.
- 1.26 -
B O O T
Tx2 - 1 6 0 0 V * . * *
P L E A S E W A I T
< < L O C A L > >
M E D I A S E L EC T
R O L L < >
< < L O C A L > >
w i d t h : * * * * m m
L E A F