Setting The Ink Drying Time [Drying Time] - MIMAKI Tx2-1600 Operation Manual

Setting the ink drying time [DRYING TIME]

This function sets an ink drying time.
The drying time is the wait time by scanning and the time interval between the instant at which
the printing operation is completed.
Specify the time to be established in accordance with the printing resolituion on a drawing
and the type of fabric to be used.
STEPS:
1. Select a type. (see page 3.3)
Here, select [Type.1].
2. Press the [ENTER] key.
3. Press the JOG keys [ ] and [ ] to select
[DRYING TIME].
4. Press the [ENTER] key.
5. Press the JOG keys [ ] and [ ] to set a drying
time after the scanning.
This is the drying time from the instant at which the carriage
returns to the capping station till the instant at which the car-
riage starts moving again for printing. The drying time that can
be set is 0.0 second to 9.9 seconds.
Here, select 1.0.
6. Press the [ENTER] key.
7. Press the [END] key twice.
The menu returns to the LOCAL mode.
- 3.12 -
S E T U P
S E L E C T : T Y P E . 1
T Y P E 1
M E D I A CO M P . < e n t >
T Y P E 1
D R Y I N G T I M E < e n t >
T Y P E 1
E A C H L I N E = 0 . 0 s
T Y P E 1
E A C H L I N E = 1 . 0 s
T Y P E 1
D R Y I N G T I M E < e n t >
< < L O C A L > >
w i d t h : 1 2 7 2 m m