Dmotion Detector Setting - Sanyo VCC-ZM400P Instruction Manual

VIEW SETTING
MOTION detector setting
D
This function divides the monitor screen into 48 zones (8 x 6). Based on information from the separate zones, target images that show
intruder movements are detected and an alarm is generated. The degree of motion to be detected can be finely set.
Note:
• Before activating this setting, use the cursor button to select a surveillance location that will not detect motion.
• When SHUTTER speed is in LONG mode and IRIS SETTING has SENSE UP activated, the MOTION function cannot be turned ON.
1
MAIN MENU
LANGUAGE SET ‚
CAMERA ID OFF
SYNC INT
PRIVACY MASK SET ‚
LENS SET ‚
MIRROR OFF
VIEW SETTING 1 ‚
OPTION SET ‚
PRESET OFF
MENU END
1
Use the cursor button (j or l) to move the cursor to
VIEW SETTING, then press the SET button. (e.g. 1)
The VIEW SETTING 1 screen will appear.
2
Use the cursor button (j or l) to move the cursor to
MOTION, and then use the cursor button (d or c) to
select ON. Then press the SET button.
The MOTION SETTING screen will appear and SET for SIZE will
be blinking.
2
VIEW SETTING 1
IRIS MANU ‚
WHITE BALANCE ATW ‚
SHUTTER LONG ‚
MOTION ON ‚
APERTURE ON ‚
GAMMA ON
PRESET OFF
MENU BACK
3
MOTION SETTING
SIZE SET ‚
MASKING ON ‚
SENSITIVITY SET ‚
ZOOM OFF
INTERVAL 5S
ALARM SIGN OFF
PRESET OFF
MENU BACK
3
MOTION SIZE setting
Sets the target object size desired for detection in the 48 zone
screen.
Press the SET button again.
The MOTION SIZE screen appears and the "1" for "V" will be
blinking.
MOTION SIZE
V 1
H 1
PRESET OFF
MENU BACK
48