Motion Detector Setting - Sanyo VCC-XZ400P Instruction Manual

MOTION detector setting

This function divides the monitor screen into 48 zones (8 x 6). Based on information from the separate
zones, target images that show intruder movements are detected and an alarm is generated. The
degree of motion to be detected can be finely set.
Note:
Before activating this setting, use the
CURSOR button to select a surveillance
location that will not detect motion.
When SHUTTER speed is in LONG mode
and IRIS SETTING has SENSE UP
activated, the MOTION function cannot be
turned ON.
In the VIEW SETTING screen, use the
CURSOR button (jldc) to select ON for
MOTION, then press the SET button.
The MOTION SETTING screen will appear.
MOTION SIZE setting
A
Sets the target object size desired for detection
in the 48 zone screen.
1
Use the CURSOR button (j or l) to
move the cursor to SET for SIZE, then
press the SET button.
The MOTION SIZE screen will appear.
1 V: vertical pattern
2 H: horizontal pattern
2
Use the CURSOR button (jldc) to set
the target object size desired for
detection in the 48 zone screen.
To return the settings in this screen to their
defaults, change PRESET to ON and then
press the SET button.
To close the menu screen or return to the
previous screen, select BACK or END for
MENU and press the SET button.
34