Sanyo VCC-ZM400P Instruction Manual page 26

LENS SETTING (LENS)
3
D/N SETTING - AUTO
AGC MAX GAIN +9·
DNR OFF
BURST OFF
FOCUS 1
LEVEL MID
PRESET OFF
MENU BACK
3
AGC MAX GAIN setting
Use the cursor button (j or l) to move the cursor to
AGC MAX GAIN, and then use the cursor button (d or
c) to select the gain.
Available settings: Select the maximum AGC gain from
4
DNR setting
Use the cursor button (j or l) to move the cursor to
DNR, and then use the cursor button (d or c) to select
the digital noise reduction setting (e.g. ON).
Available settings:
• ON: DNR (digital noise reduction) is applied. This reduces
interference at low luminance levels.
• OFF: DNR is not applied.
Note: Digital noise reduction operates when the gain control
increases. In addition, blurring and ghosting of images
can occur when moving images are being monitored,
and so the resolution is also reduced slightly.
25
4
D/N SETTING - AUTO
AGC MAX GAIN
DNR
BURST
FOCUS
LEVEL
PRESET
MENU
+9dB, +12dB or +15dB.
5
D/N SETTING - AUTO
+9· AGC MAX GAIN
ON DNR
OFF BURST
1 FOCUS
MID LEVEL
OFF PRESET
BACK MENU
5
BURST setting
Use the cursor button (j or l) to move the cursor to
BURST, and then use the cursor button (d or c) to
select the burst setting (e.g. ON).
Available settings:
• ON: The color burst signal is turned on.
• OFF: This should normally be set to "OFF".
6
FOCUS setting
Use the cursor button (j or l) to move the cursor to
FOCUS, and then use the cursor button (d or c) to
select the focus setting (e.g. 1).
Available settings:
• 1: Near-infrared wavelength correction is set.
(around 900 nm)
• 2: Visible light spectrum is set.
Note: This is set to "1" at the time of shipment from the
factory. If the images are out of focus, change it to "2".
6
D/N SETTING - AUTO
+9· AGC MAX GAIN
ON DNR
ON BURST
1 FOCUS
MID LEVEL
OFF PRESET
BACK MENU
+9·
ON
ON
1
MID
OFF
BACK