Motion Detector Setting Example - Sanyo VCC-6975 Instruction Manual

USING THE MENU SCREEN

Motion detector setting example

After the camera has been connected to the peripheral devices (VCR, multiplexer, etc.) set the
MOTION item to send an alarm trigger to the peripheral devices when the set movement
parameters are met.
Checking the detected movements set by the MOTION item
If the MOTION item settings are not made properly, the desired results will not be obtained. To test
for correct detection, please proceed as follows.
There are two setting checking methods, using the ADJUSTMENT FOR MOTION screen ZOOM or
ALARM SIGN.
A) The image is zoomed in when a movement is detected
Set the ZOOM item to 5S. When the motion detector senses a movement from a subject on the
screen, the image is zoomed in.
B) The camera ID flashes on-screen when a movement is detected
Set the ALARM SIGN item to ON, then exit the menu screen. When the motion detector senses
a movement from a subject on the screen, the camera ID is displayed on-screen.
Note: The camera ID will not be displayed while a menu is displayed on-screen.
45
English
MOTION/Example
CAMERA 1